Industrial Pipes & Valves · SUB-CATEGORY
Pipe Fittings
A complete piping system depends as much on its fittings as on the pipe itself. Our pipe fittings range spans the full set of butt weld, socket weld, and threaded configurations — in carbon steel, stainless steel, alloy, and duplex grades — to suit every change of direction, size transition, or branch connection in your pipeline layout. Each fitting meets the dimensional and material requirements of ASME, ASTM, and MSS standards, making them compatible with the specifications demanded by major GCC operators and EPC contractors. Shop our fittings range and keep your project moving.
2 sub-categories
6 approved brands
Other sub-categories in Industrial Pipes & Valves
PRODUCTS
On the shelf — Pipe Fittings.
Showing 12 of 24 · in stock today
RO-WN-A105-2-150
Elbow (45° & 90°)
A curved fitting that redirects pipeline flow at a set angle, available in long-radius and short-radius configurations.
RO-WN-LF2-3-300
Equal Tee
A T-shaped fitting that splits or combines flow into two equal-diameter branches from a single run.
RO-WN-316L-4-600
Reducing Tee
A tee with a smaller branch outlet, used to tap off a portion of flow to a downstream pipe of lesser diameter.
RO-SO-A105-2-150
Concentric Reducer
A cone-shaped fitting used to transition flow between two pipe sizes while keeping the pipe centreline aligned.
RO-SO-A105-6-300
Eccentric Reducer
An offset-centre reducer used on pump suction lines and horizontal runs to prevent air pockets and maintain gravity drainage.
RO-SO-A105-6-300
Pipe Cap
A dome-ended fitting that permanently or temporarily seals the open end of a pipeline or equipment nozzle.
RO-BL-A105-4-150
Stub End
A short pipe section with a flanged backing ring face, used with lap joint flanges in corrosive or frequently dismantled services.
RO-BL-A105-4-150
Cross Fitting
A four-way fitting that creates a perpendicular junction between two crossing pipelines in complex process layouts.